So over the years finding a solid misting system is always a constant challenge as technology grows though it’s getting better. This is how we setup our mister nozzles at Aeroponic Growers. A 1/4” OD push fit stem tee to a 90 degree angle push fit to 1/8th” FNPT opening. We screw the misters into the threaded opening. Mounting the tubing on both sides is important and you may need to get inventive with placing your nozzles.
I've been looking for those elbows...any suggestions?
Hope to see you back again
Thanks for sharing. You should become an Amazon affiliate! 😀
Ok so what I want is a bulkhead connector with 1/4 push connect on one side and 1/8 nptf on the other side
Hi, great job as always, do you have any links to the spray nozzles and elbow fitting..thanks for your help 👍